Laser ablation of polymers: dynamics analysis
- Authors: Tolstopyatov E.M.1, Ivanov L.F.1, Grakovich P.N.1, Kalinin L.A.1, Allayarov S.R.2
-
Affiliations:
- V.A. Belyi Metal-Polymer Research Institute, National Academy of Sciences of Belarus
- Institute of Problems of Chemical Physics, Russian Academy of Sciences
- Issue: Vol 58, No 6 (2024)
- Pages: 464-471
- Section: ЛАЗЕРНАЯ ХИМИЯ
- URL: https://ruspoj.com/0023-1193/article/view/681213
- DOI: https://doi.org/10.31857/S0023119324060065
- EDN: https://elibrary.ru/THSRPA
- ID: 681213
Cite item
Abstract
The variation of the principal force parameters associated with polymethylmethacrylate ablation by means of continuous CO₂ laser radiation was subjected to investigation. The complex parameter, defined as the sum of the target weight and the reactive recoil force of the ablation flux, was measured using a force-measuring device with computer registration and a time resolution of 126.5 ms. The experimental data for the initial interval of 0-2 s were approximated by a model function, which enabled the identification of changes in the target weight and recoil force of the ablation flux during irradiation. The energy efficiency of the process in a low thrust jet engine (Cm = 115 μN/W) has been determined for the moment when the ablation rate reaches the stationary regime. This decreases with the laser irradiation time due to the formation of a crater with a concave surface and an increase in the gas pressure in the ablation chamber. It should be noted that the type of the ablation curve and, consequently, the approximating function for the initial stage of ablation are specific to each polymer and laser beam parameter.
Full Text

About the authors
E. M. Tolstopyatov
V.A. Belyi Metal-Polymer Research Institute, National Academy of Sciences of Belarus
Author for correspondence.
Email: etolstopy@mail.ru
Belarus, Gomel
L. F. Ivanov
V.A. Belyi Metal-Polymer Research Institute, National Academy of Sciences of Belarus
Email: etolstopy@mail.ru
Belarus, Gomel
P. N. Grakovich
V.A. Belyi Metal-Polymer Research Institute, National Academy of Sciences of Belarus
Email: etolstopy@mail.ru
Belarus, Gomel
L. A. Kalinin
V.A. Belyi Metal-Polymer Research Institute, National Academy of Sciences of Belarus
Email: etolstopy@mail.ru
Belarus, Gomel
S. R. Allayarov
Institute of Problems of Chemical Physics, Russian Academy of Sciences
Email: sadush@icp.ac.ru
Russian Federation, Chernogolovka
References
- Krasovskiy A.M., Tolstopyatov E.M. // Surface. Physics, Chemistry, Mechanics. 1985. № 1. P. 143.
- Korshak V.V., Said-Galiev E.E., Nikitin L.N. Gribova I.A. // Dokl. of the USSR Academy of Sciences.1983. V. 269. P. 1119.
- Tolstopyatov E.M., Grakovich P.N., Ivanov L.F. // Izv. AN BSSR. Ser. chem. nauk. 1989. № 4. P. 23.
- Korshak V.V., Gribova I.A., Said-Galiev E.E. // Mechanics of Composite Mater.1987. № 6. P. 985.
- Said-Galiev E.E., Nikitin L.N. // Mechanics of Composite Mater. 1992. № 2. P. 152.
- Krasovskiy A.M., Tolstopyatov E.M. Obtaining thin films by polymer atomisation in vacuum. Moscow: Science and Technology, 1989. 181 p.
- Tolstopyatov E.M., Ivanov L.F., Grakovich P.N., Krasovsky A.M. // Proc. SPIE. 1998. V. 3343. P. 1010.
- Tolstopyatov E.M. // J. Phys. D: Appl. Phys. 2005. V. 38. P. 1993.
- Grakovich P.N., Ivanov L.F., Kalinin L.A. // Journal of General Chemistry. 2009. vol.79. P. 626.
- Tolstopyatov E.M., Grakovich P.N., Rakhmanov S.K., Vasilkov A.Yu, Nikitin L.N. // Inorganic Materials: Appl. Res. 2012. V. 3. P. 425.
- Tolstopyatov E.M., Grakovich P.N., Ivanov L.F., Allayarov S.R., Olkhov Yu. A., Dixon D.A. // J. Rus. Laser Res. 2015. V. 36. P. 485.
- Allayarov S.R., Kalinin L.A., Tolstopyatov E.M., Grakovich P.N., Ivanov L.F., Dixon D.A. // J. Rus. Laser Res. 2017, V. 38. P 364.
- Allayarov S. R., Tolstopyatov E.M., Dixon D.A., Kalinin L.A., Grakovich P.N., Ivanov L.F., Golodkov O.N. // J. Rus. Laser Res. 2017. V. 38. P 369.
- Frolov I.A., Allayarov S.R., Kalinin L.A., Dixon D.A., Tolstopyatov E.M., Grakovich P.N., Ivanov L. F. // J. Rus. Laser Res. 2018. V. 39. P. 98.
- Frolov I.A., Allayarov S.R., Kalinin L.A., Bogdanova Y.G., Tolstopyatov E.M., Grakovich P.N., Ivanov L.F., Dremova N.N., Golodkov O.N. // High Energy Chemistry. 2019. V. 53. P. 464.
- Allayarov S.R., Confer M.P., Dixon D.A., Rudneva T.N., Kalinin L.A., Tolstopyatov E.M., Golodkov O.N. // Polymer Degradation and Stability. 2020. V. 181. 109331.
- Phipps C., Luke J. // Abstr. Book of E-MRS Spring Meeting, Strasbourg, 10–13 June 2003 / The European Research Society. Strasbourg, 2003. H-VIII.2.
- Phipps C., Birkan M., Bohn W. et al. // J.Propulsion and Power. 2010. V. 26. P. 609.
- Frolov I.A., Allayarov S.R., Tolstopyatov E.M., Utkin A.V., Grakovich P.N., Ivanov L.F., Makarenko V.M. // High Energy Chemistry. 2022. V. 56. P. 64.
- Frolov I.A., Allayarov S.R., Kalinin L.A., Tolstopyatov E.M., Grakovich P.N., Ivanov L.F. // High Energy Chemistry. 2022. V. 56. P. 445.
- Madorsky S. Thermal decomposition of organic polymers / Transl. from English, ed. by S.R. Rafikov // M.: Mir, 1967. 328 p.
- Technology of Thin Films (Reference Book) / Ed. by L. Myssel, R. Glang: Transl. from English, ed. by M.I. Elinson, G.G. Smolko, V. 1. M.: Sov. Radio, 1977. P. 664.
- https://webbook.nist.gov/cgi/cbook.cgi?ID=C80626&Units=SI&Type=IR-SPEC&Index=0#IR-SPEC
Supplementary files
